Suchergebnisse

Heavy metal-loaded almond shell was subjected to pyrolysis to understand the effect of the presence of different heavy metals on its thermal degradation. Pyrolysis behavior of native and metal-loaded samples was studied by thermogravimetric analysis. Similar shapes of thermogravimetric curves indicate that the presence of cadmium (Cd), chromium (Cr), copper (Cu), nickel (Ni) and lead (Pb) did not change the main degradation pathways of almond shell. However, the temperature at which the decomposition in each stage takes place at a higher rate and char yield was considerably modified by the presence of Cr and Ni. Then, pyrolysis tests of the almond shell samples were performed in a moving tubular reactor at 700 °C. Gases and volatile organic compounds were collected using Tedlar bags and semivolatile organic compounds were collected using a resin as adsorbent. Significant changes were obtained in the composition of the gaseous fraction as a result of the metal impregnation. The main changes in the composition of the gas were observed for Ni-loaded sample, which presented the highest H2 and CO yields. Also, the yields of most of the light hydrocarbons decrease in the presence of metal, while the rest remain quite similar. The total PAH yields reached 103 μg/g for nickel-loaded sample (Nisingle bondAS), 164 μg/g for copper-loaded sample (Cusingle bondAS), 172 μg/g for lead-loaded sample (Pbsingle bondAS), 245 μg/g for native sample (AS), 248 μg/g for cadmium-loaded sample (Cdsingle bondAS) and 283 μg/g for chromium-loaded sample (Crsingle bondAS). Nickel is the most effective in the higher aromatic tar reduction, followed by Cu and Pb, whereas the presence of Cd does not affect the total emissions of PAHs. Finally, the carcinogenic potency of the samples was calculated. Native sample and the sample loaded with Cr presented slightly higher values associated to the presence of small amounts of benzo(a)pyrene. ; This work was supported by the University of Granada, Spain [project PP20I5-12 "Characterization and management of byproducts generated in the gasification process of a metal-loaded waste after its use as heavy metal bioadsorbent"); the Ministry of Economy and Competitiveness, Spain [project CTQ2016-76608-R]; and the Valencian Community Government, Spain [project PROMETEOII/2014/007].

The excessive use of plastic in our society is causing a massive accumulation, since it is a non-biodegradable product and with still poor recycling rates. This effect can be observed in the seas, which more and more plastic waste are accumulating. The present work is a critical review, based on all currently available literature, that reports environmental status of marine plastic pollution, especially microplastic pollution, in Spain. The three Spanish water areas with the highest presence of plastics are the Alboran Sea, the Gulf of Alicante and the vicinity of Barcelona probably related to fishing and industrial activities and high population densities. With regard to microplastic contamination on beaches in Spain, annual monitoring by the Spanish government shows contamination along the entire coast of the country, with particularly high concentrations in the Canary Islands (between 800 and 8800 particles/m2 in spring). Between 40 and 50% of the particles analyzed were pellets and the main factors postulated for the distribution of these particles are marine currents and the geomorphological characteristics. With regards to biota, ingestion of microplastics by fish has been intensely confirmed and, important differences were observed between the locations of the sampling, being bogues (Boops boops) one of the fish species more studied in Spain. Finally, the work includes a revision of European and Spanish legislation about plastics and marine pollution and some strategies to reduce this kind of contamination in Spain.